Special attention is needed regarding the black arrows on the ends of the hinge line. So, an hinge line (in orange on figure 12) which define the cross section to be projected should be positioned at the desired place over the placed view.
This can be done through the button Section View, as shown on figure 11.Īfter the Section View dialogue windows pop up, the placed view should be selected. It is also possible to add section views to better detail the model. The view creation process result can be seen on figure 10. Over the tab Layout (figure 9), it is possible to select the placement method and if you want to add any additional view to the drawing. Over the tab Orientation (figure 8), it is possible to select the view that you want to draw, including three dimensional ones, like Isometric. Over the tab Options (figure 7), it is possible to select the draw scale ratio and some options about lines and preview style.įigure 7 – Customizing the 2D draw aspect. In this case it will be selected the entire assembly. Over the tab Part (figure 6), it is possible to select the part which you want to have the 2D drawing. Using the button View Creation Wizard (figure 5), it is possible to add a desired view to the drawing paper. Here it is possible to define some drawing main identification fields, located at the lower-right corner of the paper.įigure 4 – Populate Title Block dialogue window.Īfter the paper was completely defined, the 2D drawing can be added. After the sheet is selected the Populate Title Block dialogue window (figure 4) will appear. Here, it is possible to choose between pre-defined templates for the paper or even create a new one. Once the Drafting application is launched, the Sheet dialogue window (figure 3) will appear. This will disables the Modelling application and start the Drafting application.įigure 2 – Starting the Drafting application. With the 3D model opened at NX, go to File > Drafting. In this basic example, we are going to use the 3D model on figure 1 .įirstly, we need to start the Drafting application. It is possible to create a 2D drawing from a 3D model using the NX Drafting application.
Parametric Ship Design A Simple Application in HTML + Javascript.Ship Design Layout Tool – A Web-based App Prototype.Table of Offsets – 3D plot and Hull Lines.3D Vessel Assembler – Virtual Assembly Prototype.6DOF (Surge, Sway, Yaw, Roll, Heave, Pitch).